All Sheffield made, the new Hill EVO 310 Electronic Compressor is reliable and durable and the new EVO version has introduced improvements and new features. The Hill EVO 310 Electric Air Compressor is designed to fill cylinders and tanks that are being used solely for Air Gun charging and use

The Evo benefits from completely new electronic architecture along with completely new software, as with all Hill products the electronics have been designed and tested in house by their own software and electronics engineers.

Hill EVO 310 Electronic Compressor Features:

• Can be set as low as 50 bar (755 psi) and up to 310 bar (4500 psi)
• Built in an Automatic Air Pressure Purge
• Super durable Shuttle Valve – very efficient and long lasting
• Highly accurate digital pressure sensor with an additional analogue gauge (no longer need to recalibrate the compressor during a major service)
• Simple to service and maintain
• Designed, manufactured and assembled by Hill Pumps in Sheffield, UK

Automatic Air Pressure Purge

This kicks in whenever the motor on the compressor stops, so when it goes into a cooling cycle and when a fill is paused or finished.

This not only takes the strain off the motor when starting again against very high pressures, but has the added benefit of purging the air, including any moisture from inside the unit.

This is very important for people filling larger rifles and or cylinders.

The new unit also benefits from our continuous improvement in R & D, including our new super durable Shuttle Valve, which we made from some quite exotic material….

Users should note that this shuttle valve does give the compressors a unique sound compared to other compressors out there on the market, but they are very efficient, extremely long lasting and when you hear that sound you will now instantly that it is a Hill Compressor!

We have built in a new highly accurate digital pressure sensor with an additional analogue gauge, this is extremely accurate, but also means that you no longer need to recalibrate the compressor during a major service.

The Evo 310 can be set as low as 50 bar (755 psi) and up to 310 bar (4500 psi).

The Evo 310 also benefits from completely new electronic architecture along with completely new software, as with all Hill products the electronics have been designed and tested in house by our own software, and electronics engineers, and believe it or not the PCB’s are manufactured here in Sheffield too.

If you are looking for the ultimate in moisture protection for your gun and compressor you can add The Hill Dry-Pac Pro which is fully compatible with the Evo 310, EC-3000 evo and the original EC-3000 models.

Both our crank and silicone oils have been specifically manufactured and designed for use with the Evo 310, EC-3000 and EC-3000 evo Electric Compressors. No other oils should be used with the Evo 310, EC-3000 or EC-3000 evo.

The Crank Case Oil (Red) is in the perfect size bottle for the unit as it takes almost the whole bottle to fill the crank properly on the initial fill, and should not need topping up for some time. When filling the crank oil please ensure that it is filled properly, this should require near enough the whole 50ml bottle.

The Silicone Oil (Clear) is used all the time by the pump and should need replacing after approximately 50 hours of run time, this is also the correct point to change the Crank Oil.